GM 4T60E, 4T65E Low Profile Transmission Pan


GM 4T60E, 4T65E Low Profile Transmission Pan

from 215.00

Fits 1990s and newer front-wheel-drive GM cars

Available in 3 finishes!

Add To Cart


  • Volume: Stock
  • Number of Bolts: 20
  • Increased oil capacity for cooler temperatures
  • Sand-cast aluminum with raised fins
  • 3/16-inch thick wall construction to add strength to the transmission case
  • 3/8-inch thick gasket flange will not bend when bolts are tightened
  • Machined gasket surface for a secure seal
  • Boss cast into pan can be machined for a temperature sensor
  • Magnetic drain plug for easier, less messy maintenance
  • Mounting hardware provided
  • Click here for dimensions
  • Can be machined for a temperature sensor

NOTE: GM uses two different bolt holes on these transmissions, so two different bolt sizes are available. You will need to measure your bolt thread diameter and order the correct part for your needs. P/N 10758-1 is for 6mm bolt holes and P/N 10758-2 is for 8mm bolt holes. If you order the wrong size bolts, you will not be able to install the transmission. We know it is a hassle to check. We recommend you pull out one of your stock bolts and measure the thread diameter. The 8mm bolt (measured over the threads) is approximately 7.85mm and the 6mm bolt is approximately 5.9mm.