Acculink Installations for Barry Grant Six Shooter ®

1. Follow all the normal instructions for Acculink.
2. Install Acculink on the center carb only.
3. Remove the connecting rod from the front to rear carb and install spacers using longer bolts provided.
4. Re-use the original locking nuts.
5. Check linkage clearance at all throttle positions.
6. Install pins in ratio arm using Loctite ®
7. Adjust Acculink TPS so there is no play in the adjustable link rod, the TPS must have some preload.
8. Check full stroke so that the TPS does not hit the end of travel mechanically. This can damage the sensor and make Compushift not work. The ratio arm has a long end and a short end. This will allow you to choose a stroke that will not damage the sensor.
   The long end UP makes the stroke shorter and the short end UP makes the stroke longer. This moves the pivot point closer and farther from throttle shaft center.